Consonance D-Linear7 사용자 설명서 - 페이지 2

{카테고리_이름} Consonance D-Linear7에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Consonance D-Linear7 14 페이지. High definition digital music interface

Power Source

The equipment should be connected to a power supply only of the type described in this

manual or as marked on the equipment.

Grounding or Polarization

Power supply cords should be routed so that they are not likely to be walked on or pinched by

items placed upon or against them, paying particular attention to cords and plugs,

convenience receptacles, and the point where they exit from the amplifier.

Ventilation

The equipment should be situated so that its location or position does not interfere with its

proper ventilation.

1. The equipment must not be placed on bed, sofa, or similar surfaces, that may block the

ventilation openings,

2. The equipment must not be placed in a built-in installation, such as a bookcase or cabinet

that may impede the flow of air.

3. The equipment should be situated away from heat sources such as radiators, heat

intended for commercial use.

Water and Moisture

The equipment should not be used near water, e.g., near a bathtub, washbowl, kitchen sink,

laundry tub, in a wet basement, or near a swimming pool etc. Similarly, do not placed objects

filled with liquid, such as vases on top of the equipment.

Lighting

Consonance hi-fi system can be damaged by lightning. Power amplifiers are particularly at

risk and therefore should be turned off when there is risk of lightning strike. For complete

protection all mains plugs and any aerial cables should be disconnected when not in use.

Power Lines

In case of connecting a tuner, an outdoor antenna should be located away from power lines. If

an outside antenna is connected to the system, be sure the antenna is grounded so as to

provide some protection against voltage surges and built up of static charges.

Cleaning

Never clean with furniture polish, benzene, or volatile liquids. Dust periodically with a clean,

soft paint brush. Fingerprints can be removed with a moist polishing cloth.