Belden FX FUSION SC CONNECTOR 설치 매뉴얼 - 페이지 2
{카테고리_이름} Belden FX FUSION SC CONNECTOR에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Belden FX FUSION SC CONNECTOR 8 페이지. 900μm tight buffer/250μm
Belden FX FUSION SC CONNECTOR에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지)
페이지 인쇄
Fusion Splicer Heat Settings
Model
Belden FXFSTOSPL
Sumitomo Q101-CA
AFL/Fujikura 70S
AFL/Fujikura 62S
Fiber Fox Mini 6S
Greenlee 910FS
Fitel S178A
NOTE:
Select preprogrammed heat settings and edit the temperature/time as shown.
For additional fusion splicer models and splice holders, refer to document
www.belden.com/splice-on
When installed on a live
system, invisible laser
radiation may be present.
Do not stare into connector
end face or view directly with
optical instruments.
Materials cleanliness and maintenance:
• Keep the dust cap on and avoid
dust creating activities.
• Maintain the fiber components
clean as your working area.
• If the cleaver does not work
properly rotate the blades
by following the cleaver
manufacturer instructions.
= This symbol indicates risks and hazards that may cause eye injuries.
= This symbol indicates the presence of a risk that can cause personal injuries or components damages.
FX FUSION SC CONNECTOR
900µm TIGHT BUFFER/250µm - INSTALLATION GUIDE
Temp.
Time
180°C
30 sec.
180°C
30 sec.
180°C
25 sec.
180°C
40 sec.
180°C
30 sec.
180°C
40 sec.
180°C
40 sec.
Security precautions:
Instructions for Cleaver:
PX106500-EN REV E
Prepro-
grammed
heat setting
FX SC Fusion
60mm 0.9
60mms/FP-03
60mms/FP-03
Long
60mm
SOC
AEN-1701
Wear safety glasses when
working with optical fiber.
Dispose of all scrap fiber in the
waste bottle to avoid getting
fiber slivers.
Do not touch cleaver blade.
• Clean end face with alcohol
wipes and then dry wipe as
cleaning procedures.
• Clean the cleaver blade with
alcohol wipes.
Splice
Holder Part
Number
FXFSSHFM2
FXFSSHFM1
FXFSSHFM3
FXFSSHFM4
available at:
Page 2 of 8