Beldray BA488430HSMFOB 사용 설명서 - 페이지 4

{카테고리_이름} Beldray BA488430HSMFOB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Beldray BA488430HSMFOB 7 페이지. Large electric stove with flame effect

Instructions for Use

Operating the Fire

Plug the fire into the mains power supply and switch on if applicable.

Do not use any form of adaptor, extension lead or timer.

Press switch 1 to operate the flame effect and to turn the fan on without the heating function.

For a low level heating, press switch 2 for the 1000W setting.

For full heating turn on switches 2 and 3 for the 2000W setting.

Adjust the thermostat to finely regulate the temperature; turn it clockwise to increase the heat

output and anticlockwise to reduce it.

To vary the brightness of the flame effect, rotate the flame brightness dial clockwise to increase

the brightness and anticlockwise to lower the brightness level.

Thermostat Instructions

The sensitive hot air control (thermostat) will constantly maintain a pre-programmed

temperature due to its automatic operation.

Turn the temperature adjustment dial switch to the right, towards the maximum level.

Leave the switch in this position until the room reaches the desired temperature.

This appliance is supplied with two 40 watt bulbs (E-12). When they require replacing, loosen

the two screws on the panel at the back of the fire.

Remove the panel and unscrew the bulbs.

Caution: There may be sharp edges; exercise extreme caution to avoid injury.

Always replace the bulbs with identical ones of the same wattage.

To reassemble, proceed in the reverse order.

Cleaning and Maintenance

Before attempting any cleaning or maintenance, unplug the fire from the mains power supply and

allow it to cool fully.

Clean the fire with a soft, damp, lint-free cloth and dry thoroughly.

Do not immerse the fire in water or any other liquid.

Do not use harsh or abrasive detergents or scourers.

Supply: 220-240V~50Hz

Power: 2000W

THE SCIENCE

BEHIND HEAT

BA488430HSMFOB Large Electric Stove with Flame Effect