Dante DFG48044X 설치 및 운영 매뉴얼 - 페이지 9
{카테고리_이름} Dante DFG48044X에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dante DFG48044X 18 페이지. Digital fiber optic ethernet edge switch 10/100mbps standalone unit
페이지 인쇄3.0 INSTALLATION
This section describes the installation of the Dante Security DFG48044X Series Edge Switches, including
location, mountings, power supply options and media connection.
3.1 Locating the Edge Switch Unit
All the DFG48044 Series Switches operate in transparent half-
and full-duplex mode. The store and forward switch easily
takes care of network traffic and can be used as a useful,
economical tool to expand an existing network. The compact
and lightweight design of the Dante Security DFG48044 Series
allows it to be easily installed in almost any location. A Velcro
strip may be used for mounting the unit on a vertical surface
such as a wall or cabinet, or for securing the unit on a table-top
or shelf. Alternatively, metal mounting clips and screws are
included for a rugged and secure mounting in any orientation.
Installation of the Dante Security DFG48044X Series Edge Switches is a simple procedure. The installation
location is dependent upon the physical layout of the Ethernet network and associated cabling. Make sure the
unit is installed in a location that is easily accessible to an AC power outlet or the appropriate DC source and
where cooling is not inhibited. The green Power (PWR) LED must turn ON when power is applied.
For 19" rack-mounting of Dante Security DFG48044
series Edge Switches, a rack-mount tray is available,
the DFG48000 FRAME. The Edge Switches are
mounted with the DC power jack in the back, with the
fiber and the RJ-45 connectors in the front. Any mix of
the Edge Switches and/or Media Edges may be placed
on a tray, up to a maximum of 8 units. (The mounting
spaces of the DFG48000 FRAME are specific to the
Magnum products and will not permit other models to
be properly mounted).
In a typical installation, the MC14-TRAY, 19" rack-mount tray will hold a few (three to eight) DFG48044X Series
Edge Switches, with their power supplies plugged into power strips in the rear area of the tray. Metal mounting
screws in the bottom-front hold the Edge Switches firmly in place. The beveled-top edge of the units permits
the LEDs of each unit to be viewed for operational status, even when the units are very close together.