Consort SLVTB 설치 및 제어 매뉴얼 - 페이지 3

{카테고리_이름} Consort SLVTB에 대한 설치 및 제어 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Consort SLVTB 4 페이지.

3. Timer Mode

For timer mode, the switches are set as shown below.

4. Choosing position in a room

The SLVTB controller should be fixed to the wall. Avoid areas with draught or direct sun. Do not position the

controller above or close to the heaters or other heat sources. Damp areas or areas where the SLVTB can be

mechanically damaged should also be avoided. Avoid installing the controller in areas where there are metal

objects between the heater and the controller. This will reduce the RF range. The RF range in ideal conditions can

be up to 50m, however this can be reduced when the signal is passing through the walls or other objects. The

range can also be affected where the controller is mounted close to power cables, motors or equipment

producing a strong electromagnetic field. If the temperature control feature is used it is necessary to use one

controller for each room or zone.

5. Installation

The controller is supplied with a white plastic back box but it was designed to fit onto most single gang back boxes.

The controller is powered by two AAA batteries that are supplied. To activate the controller pull the plastic tab

located at the + battery terminal. The batteries should be replaced every 12 months.

In timer mode, switch 3 or 4 must be in the 'ON' position. This mode allows for 3 different

settings which will alter the time period for each segment.

Switch 3 - Each time period represents 5 minutes.

Switch 4 - Each time period represents 15 minutes

Switch 3 & 4 - Each time period represents 30 minutes

Controller functionality in timer mode:

In timer mode, the controller acts as a 4 stage run-back timer. When the controller is

in stand-by mode and button is pressed, the display will show 0h00. When pressed

again the display will show time for the first stage of the run back timer in minutes

and heating is activated. When pressed again the display will show time for the

second stage and so on. Each stage is representing a time period that is selected

when setting the switches.

In the example, the only switch in the 'ON' position would be number 3. The button

would be pressed four times to activate four 5-minute segments resulting in the

heater staying on for 20 minutes. At the end of the last time period the controller is

now in stand-by mode.

In the timer mode, the heating status is indicated by letter 't' at the first display

position. If the On button is pressed the display will show remaining time. The

remaining time can be increased at any time by pressing the On button.

Heating status :

t - heating active

t flashing - heating inactive, room at

set temperature

t not shown - heating inactive

Temperature not flashing : indicating room temperature

Temperature flashing : indicating set temperature when using UP or DOWN buttons