Consort EV2310 매뉴얼 - 페이지 3

{카테고리_이름} Consort EV2310에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Consort EV2310 16 페이지.

페이지 인쇄

General informations

Introduction
This instrument is manufactured with the latest technology and needs no particular maintenance.
Consort certifies that this instrument was thoroughly inspected and tested at the factory prior to
shipment and found to meet all requirements defined by contract under which it is furnished. However,
dimensions and other physical characteristics may differ.
The normal operating temperature should be between 0° and 40°C. Never use the instrument in a room
with high humidity (>95 %) or at very low temperatures (condensation water!).
Manufacturer
Warranty
This instrument (excluding all accessories) is warranted against defective material and workmanship for
a period of thirty-six (36) months from the date of shipment ex factory. Consort will repair all defective
equipment returned to it during the warranty period without charge, provided the equipment has been
used under normal laboratory conditions and in accordance with the operating limitations and
maintenance procedures in this instruction manual and when not having been subject to accident,
alteration, misuse or abuse. A return authorisation must be obtained from Consort before returning any
product for warranty repair on a freight prepaid basis!
Consort is not liable for consequential damages arising out of the use or handling of its products.
Servicing
In the event of this instrument being returned for servicing, the owner is requested NOT to send the
following items unless they are suspect:
If serious malfunctioning occurs, stop using the unit immediately and consult your local Consort dealer.
Keyboard
During SETUP or programming a procedure:
é ê
/ 
During a PROCEDURE:
é ê
/ 
Rev. 1605
Consort bvba
Parklaan 36
B2300 Turnhout
Belgium
Manual
Cables
Accessories
= Buttons for entering a value or for selecting a function.
= Button for programming and confirming the desired parameters.
Hold this button pressed to return to the main menu!
= Button to
start the procedure (MANUAL or METHOD),
•
cancel while entering a parameter (SETUP),
•
return to the previous menu (SETUP).
•
= Buttons for selecting a display configuration.
= Button to modify the parameters.
= Button to stop or to pause the experiment.
Tel (+32)(14)41 12 79
Fax (+32)(14)42 91 79
Manual Power Supplies
1