Consort EV2650 매뉴얼 - 페이지 7
{카테고리_이름} Consort EV2650에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Consort EV2650 16 페이지.
페이지 인쇄Detection
Choose DETECTION to alter the actions when a low current or a power failure is detected.
Low Current
•
When a very low current is detected as soon as the Voltage limit has been reached, the power will
shut down the procedure. An
Power Failure
•
When the detection of a power failure is enabled, the power supply will continue to proceed the
procedure if the timer was still running at the moment that the power failure occurred. After
powering it again, the power supply will automatically proceed with the experiment for the
remaining time.
1. Follow these steps to select LOW CURRENT and press :
PROCEDURE?
MANUAL
METHOD
2. Decide whether or not the output voltage should shut down at a too low output current and
press .
3. Select POWER FAIL and press .
4. Decide whether or not the instrument should proceed with the experiment for the remaining
time after a power failure and press .
Data
To be added, check our website (www.consort.be/wiki) for firmware updates of the instrument.
This feature will allow to log all information about the executed procedures.
Info
Choose INFO to find specific information about the device, the parameter limits, the firmware version
and more:
PROCEDURE?
MANUAL
METHOD
SETUP
Rev. 1605
audible error message
SETUP
will be given.
SYSTEM
DETECTION
DATA
INFO
SYSTEM
DETECTION
DATA
INFO
Manual Power Supplies
DETECTION
LOW CURRENT
POWER FAIL
5