Consort EV3610 매뉴얼 - 페이지 8

{카테고리_이름} Consort EV3610에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Consort EV3610 16 페이지.

페이지 인쇄

Method programming

Method programming permits to store up to 9 different methods, each with 9 steps, of frequently used

parameters in the non-volatile memory for future recall. Each step is able to recall a next one, provi-

ding a flexible multiple step function for special techniques. The method mode also permits to program

a linear voltage gradient for any step provided the limiting current or power is not attained. Parameters

can be changed temporarily without interrupting the run.

1. Verify if the instrument is switched off.

2. Connect the electrophoresis tank to the instrument.

3. Switch the instrument on.

4. Select METHOD and press :

PROCEDURE?

MANUAL

METHOD

5. Select the desired method and press :

CHOOSE

METHOD

6. When previously multiple steps have been

programmed, select the desired step and

press :

METHOD 1|1

8. Enter the desired voltage limit

and press  :

METHOD 1|1

VOLTAGE

300

When performing a voltage gradient,

enter the desired end Voltage. The start

Voltage is the end point of the previous

step.

Rev. 1605

SETUP

STEP

Method/steps

7. Decide whether or not a linear voltage

gradient has to be performed

and press :

METHOD 1|1

GRADIENT

9. Enter the desired current limit

and press  :

METHOD 1|1

CURRENT

500

This limit is automatically set to

maximum and cannot be changed in case

of a voltage gradient step.

Manual Power Supplies