Consort E3200 매뉴얼 - 페이지 6

{카테고리_이름} Consort E3200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Consort E3200 16 페이지.

Fitting electrode cables

1. Note the position of the lid on the unit. This shows the cor-

2. Remove the lid from the unit. Note if the lid is not removed,

3. Screw the cables into the tapped holes as fully as possible so

4. Refit the lid.

These can be fitted to enhance visibility of the wells if desired.

They can be fitted to the white vinyl platform sheet or to the

unit itself.

1. Seat the tray in the unit and note the position of the comb

2. Remove the tray.

3. Peel the back off of the loading guide and carefully apply the

rect polarity and the correct orientation of the cables, black

is negative and red positive.

fitting the cables may result in un-tightening of the gold plug

and damage to the electrode.

that there is no gap between the lid and the leading edge of

no gap between the lid and the leading edge of

the cable fitting.

grooves. The samples run black to red but the trays can be

used frontward or backwards so ensure that the comb grooves

closest to the black electrode are marked.

loading guide directly to the gel platform.

E3xxx