Danterm ACT 7 빠른 시작 매뉴얼 - 페이지 13
{카테고리_이름} Danterm ACT 7에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danterm ACT 7 16 페이지.
페이지 인쇄Turning off
If you wish to turn the device off and disconnect the power
supply, switch the device to standby for a minimum of
30 minutes to allow for the condensate pump to drain
the system. The hoses and the mains power can then be
disconnected.
Failure to follow the above procedure may result in
excess water being retained in the system which may
spill when the ACT 7 is moved.
Routine maintenance
The air filter must be kept clean. Never allow the filter to
become obstructed with dust or dirt. If allowed to do so, poor
performance and component damage may occur. The filter
is fitted to the rear of the panel shown below and is held
on with magnets. Remove the panel by pushing the panel
up using recesses at the bottom. Remove the filter, vacuum
excess dirt, and wash it with soapy water. Leave the filter to
dry before refitting it and operating the ACT 7.
Push cover up
Recesses
13
ACT 7 QUICK START GUIDE