Addonics Technologies ST45HPMXA-B 사용자 설명서 - 페이지 4

{카테고리_이름} Addonics Technologies ST45HPMXA-B에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Addonics Technologies ST45HPMXA-B 8 페이지. Storage tower

Resetting the RAID Mode

NOTE: This procedure destroys all RAID data. It should not harm individual drives or their

contents; however, creating or running backups of all data is strongly recommended before

proceeding.

1. Power down the unit and set the dip switch to the factory default setting

(all switches OFF).

2. While holding the SET button with a ballpoint pen, turn the unit on. A

long beep will sound from the Port Multiplier. The SET button may be

released once the long beep stops.

Setting or Modifying the RAID Mode

NOTE: Setting or modifying the RAID mode destroys all data.

1. Follow the procedure for resetting the RAID Mode.

2. Power down the unit and set the dip switch to the desired RAID Mode.

3. While holding the SET button with a ballpoint pen, turn the unit on. A

long beep will sound from the Port Multiplier. The SET button may be

released once the long beep stops.

If instead of a long beep the Port Multiplier sounds a series of short beeps,

an error has occurred during configuration of the array.

Windows users may install the JMicron HW RAID Manager application

located on the SATA Controller CD. In the CD, browse to Configuration

Utilities → JMB393. The JMicron HW RAID Manager can be used to

create, modify, and monitor the health status of the RAID drives, and

provide status alerts. When configuring the RAID mode using the RAID

Manager application, it is strongly recommended to leave the dip switch in

the factory default setting.

Using identical drives for all settings other than JBOD or LARGE is

strongly recommended. Creating a LARGE array using drives that have

different properties will use all space on all members, and performance

will match that of the member in use during any particular I/O operation.

Creating a RAID using drives that are not all the same size will result in all

members using only as much space as the smallest member. Creating a

RAID using drives that have different performance will degrade the overall

performance of the array.

BZS Switch (SW1:1):

The BZ switch is used to silence the audible alarm buzzer. The OFF

position permits the audible alarm, and the ON position silences the

audible alarm. The BZ switch has immediate effect.

www.addonics.com

Technical Support (M-F 8:30am - 6:00pm PST)

Phone: 408-453-6212

Email: www.addonics.com/support/query/