Constellation Altair II 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Constellation Altair II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Constellation Altair II 19 페이지.

4. RCA outputs

RCA unbalanced outputs are supplied for amps and recording devices not equipped with XLR inputs.

The signal at these outputs is the same—it does not matter if you use output 1 or output 2.

From left to right, looking at the back of the Altair II, the outputs are: 1

, 2

——2

, 1

right

left

When connecting to an amplifier, be sure to match the output to the correct channel on your amp. As

you are looking at the back of the Altair II, the outputs on the left side are for the right channel, the

outputs on the right are for the left channel. To remove an RCA plug, grasp it by the connector body

and pull the plug out.

These inputs connect to the power outputs of the Altair II's separate power supply. The Altair II

includes special spiral-wrapped, gold-plated copper cables designed for aerospace use. Each cable is

rated to handle 30 amps.

Each of these jacks mates with a matching jack on the power supply. Be sure to connect Right and Left

Analog Power jacks on the preamp to the corresponding jacks on the power supply, and the Control

Power jack on the preamp to the Control Power jack on the power supply.

Before connecting these cables, switch off the Altair II's power supply and disconnect it from the

AC power. Failing to do this can damage the Altair II or its power supply.