Constellation Argo 소유자 매뉴얼 - 페이지 17

{카테고리_이름} Constellation Argo에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Constellation Argo 20 페이지.

Step-by-step operating process

We've covered all of the basic controls and indicators of the Argo. Here's how you use them to perform the

basic operations of turning the unit on, selecting a source, adjusting the sound, and turning the unit off.

STEP 1: To turn on the Argo from the front panel, first make sure the power switch on the back of the unit is

flipped up. Now touch the touchscreen. It will illuminate and a power button will appear onscreen. To power up

the Argo, press the onscreen Power button, the middle button under the touchscreen or the Standby button on

the remote

When you turn on the power, you will hear the Argo's internal relays click as the unit goes into warm-up mode.

The touchscreen will read Powering On and the Power button will be blacked out. After about 10 seconds, an

input screen will appear and the most recently used input will be selected.

STEP 2: To change to a different input from the front panel, press the button under the Home icon. This will

bring up the input select screen. Push an onscreen button (XLR-1, RCA-1, etc.) to select the input you want. The

screen for that input will appear. Alternatively, you can scroll through the available inputs using the Input

button on the remote. Enable playback on the chosen source device.

STEP 3: Adjust listening volume with the volume knob on the front of the unit or the volume up/down buttons

on the remote. Note that the control is calibrated in negative decibels (-dB), reaching maximum volume at 0.0

dB and minimum at -99.0 dB. Thus, when you turn the volume up (clockwise), the number on the front display

will decrease. When you turn the volume down (counterclockwise), the number will increase.

STEP 4: To adjust left-to-right balance, turn the balance knob. Counterclockwise shifts the balance to the left,

clockwise shifts it to the right. Or use the buttons on the remote; left shifts the balance to the left, right shifts to

right. The onscreen indicator will show you the balance setting in 0.1 dB increments.

STEP 5: You may wish to set a maximum output level to prevent damage to your speakers if the level is

accidentally turned up too high, and a minimum output level so that the Argo always delivers an audible

volume. To do this, adjust the Argo's volume to the desired minimum or maximum level. Push the multifunction

button labeled Setup. Press either the Set Min or Set Max button, depending on which function you want. Hit

Apply to accept the setting, or Cancel to return to the original setting. To clear the setting, press either CLR Min

or CLR Max as appropriate, or press Default to clear both settings.

STEP 6: If you want to use the Argo in a home theater system, in conjunction with a surround-sound processor,

you should set up one input for home theater bypass. When you switch to this input, volume and balance will

be at fixed settings and your channel balance adjustments in the surround processor will be preserved. To do

this, first select the input you want to use for this function. Now adjust the volume on the Argo to the desired

level. Push the multifunction button labeled Setup. Push the Set Min button, then the Set Max button, then the

Apply button. To clear these settings, press CLR Min then CLR Max, or press Default.

STEP 7: To turn the system off, stop playback on the source device. Hold the Standby button in the middle

under the LCD touchscreen or on the remote down for 5 seconds. The unit will enter cool-down mode for 10

seconds, during which no buttons will work. After cool-down mode finishes, you can turn the unit back on again

as described in Step 1 above.

Maintenance

The Argo requires no regular maintenance.