Constellation audio Inspiration PREAMP 1.0 사용자 설명서 - 페이지 5

{카테고리_이름} Constellation audio Inspiration PREAMP 1.0에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Constellation audio Inspiration PREAMP 1.0 16 페이지.
Constellation audio Inspiration PREAMP 1.0에 대해서도 마찬가지입니다: 사용자 설명서 (16 페이지)

페이지 인쇄

Source components

The PREAMP 1.0 has six analog audio input, three balanced (XLR) and three unbalanced (RCA), and can

be used with any audio component with line-level analog outputs. As with the outputs mentioned

above, an XLR connection will provide the highest quality signal, and should be used when possible. If

you are using a record turntable, you will need to connect a high-quality phono preamplifier, such as

the Constellation Audio Perseus, between the turntable and the PREAMP 1.0.

In the event of malfunction

Do not under any circumstances open the chassis of the PREAMP 1.0. There are no user-serviceable

parts inside. Opening the chassis can present a shock hazard even if the AC power is disconnected. Any

alteration or modification of the PREAMP 1.0's internal parts or circuit will immediately void your

warranty.

If your PREAMP 1.0 does not function correctly, refer to the Troubleshooting section at the end of this

manual. If you are still unable to resolve the problem, contact your Constellation Audio dealer.

If any liquid is spilled on the preamp, or if any metal object (such as a staple or a paper clip) is

inadvertently forced inside, immediately disconnect the AC power and contact your Constellation Audio

dealer.

Source device and amplifier connections

1. XLR inputs

On the rear of the PREAMP 1.0 there are eight XLR inputs, four on each side. As you are looking at the

rear panel, the left four XLR inputs are for the right channel, the right four inputs are for the left

channel. Underneath each jack is the corresponding input number. Use of XLR connections is

recommended for the best possible audio quality. To remove an XLR plug, push on the tab above the

jack and pull the plug out.

IMPORTANT NOTE: To preserve true dual-mono operation, the PREAMP 1.0 uses a symmetrical circuit

layout. This configuration requires that the PREAMP 1.0's back panel connections be laid out a little

differently from those on most preamps. For example, the left-channel connection for Input 1 is at the

far right side of the back panel, and the right-channel connection is at the far left side. Connecting the

cables in the usual side-by-side fashion will result in an incorrect installation and the mixing of sounds

from different source devices.