Constellation audio Virgo 소유자 매뉴얼 - 페이지 16

{카테고리_이름} Constellation audio Virgo에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Constellation audio Virgo 18 페이지.

Maintenance

The Virgo II requires no regular maintenance.

If the preamplifier's surface becomes dusty, simply wipe it off with a soft dry cloth. Do not spray cleaners on

the surface.

To clean fingerprints from the surface of the preamplifier, spray a small amount of mild window cleaner such

as Windex onto a soft dry cloth, then use the cloth to remove the fingerprints. Do not spray the cleaner directly

onto the preamplifier.

Preamplifier will not turn on

1. Check to see if the front screen on the Virgo II is illuminated, or touching the screen lights it up. If the screen

won't light up, try the following steps in order. After you perform each step, touch the Standby button on the

front of the unit and wait a few seconds to see if front display flashes. If any one of the steps restores the

power (i.e., allows the Standby button to turn the unit on), there is no need to continue to the next steps.

A. Check power cable connections between the wall and the Virgo II's power supply. Push the wall plug

and the connector at the power supply in firmly.

B. Check power cables between Virgo II and power supply. DO NOT pull out these cables while the power

supply is on.

C. Make sure the master power switch on the rear of the power supply is turned on.

D. If the Virgo II is plugged into an AC line conditioner, make sure the line conditioner is turned on.

F. Flip the master power switch off and on again. This will reset the Virgo II's internal circuit breaker.

G. Check the circuit breaker for the AC circuit that the Virgo II is plugged into. If the breaker is tripped, flip

it back on. If it will not turn on, there is likely a short circuit somewhere in the lines or in a device

connected to this AC circuit. Check the power cords for your components to make sure none have been

damaged.

H. If none of these conditions restores power, it is possible one of the Virgo II's internal fuses is blown. Do

not attempt to change the fuse yourself—the Virgo II requires the use of special high-voltage fuses that

are not commonly available. Contact your Constellation Audio dealer for service.

Preamplifier is on but no sound is produced

1. Make sure the front display illuminates when touched, indicating that the preamp is powered up and not in

warm-up mode.

2. If the display lights up when touched, hit the Mute button on the front panel or on the remote to restore

sound.

3. If the Mute button does not restore audio, try the following steps in order. If any one of the steps restores

the sound, there is no need to continue to the next steps.

A. Check you are on the correct input. Cycle through available inputs using the front touchscreen controls,

or select the desired input using the remote.

B. Check that the source component is on and playing back—i.e., if it is a CD player, make sure that the

CD is playing and not in pause mode.

D. Check the connections between the Virgo II and your amp, and between the Virgo II and the audio

source device. If a cable is disconnected, reconnect it. If this does not restore sound, try substituting a

different set of cables in order to make sure the original set was functioning properly.

E. Check the connection between your amp and the speaker. Make sure the speaker cable has not come

loose. If it has, turn the power off on your amp, then re-install the cable.

F. Check that the volume is at a sufficient level. Do not turn the volume all the way up to check this, as if

sound is reestablished while the Virgo II is set to output maximum volume, damage can be done to your

speakers and amplifiers.