Constellation audio Performance Series DC Filter 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Constellation audio Performance Series DC Filter에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Constellation audio Performance Series DC Filter 6 페이지.

페이지 인쇄

Each cable is dedicated to a specific purpose: right channel, left channel or control. Be sure to connect

the right-channel cable to the right-channel input, the left-channel cable to the left-channel input and

the control cable to the control cable input.

Start by connecting the three cables from the power supply to the three jacks on the DC Filter. Then

connect the three cables from the DC Filter into the three jacks on the Performance Series component.

The proper connections are shown below. The component shown is the Perseus phono preamp, but the

connections are the same for the Virgo line stage and the Cygnus digital music player.

DO NOT remove the power cables while the unit is powered on. If you do happen to accidently pull

one of them out, DO NOT plug it back in. Turn off the power supply using the hard switch on the

rear panel, unplug the power supply, then replace the cable. Failure to power down the unit

before replacing a power cable can result in substantial damage to the power supply, the DC Filter

or the Performance Series component.

In the event of malfunction

Do not under any circumstances open the chassis of the DC Filter. There are no user-serviceable parts

inside. Opening the chassis can present a shock hazard even if the AC power is disconnected. Any

alteration or modification of the DC Filter's internal parts or circuit will immediately void your

warranty.