Dantherm VA-M40 MKII 서비스 매뉴얼 - 페이지 11
{카테고리_이름} Dantherm VA-M40 MKII에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dantherm VA-M40 MKII 20 페이지.
페이지 인쇄
Cabinet
Cabinet
The steel cabinet completely encloses the space heater components and systems. The
powder painting finish is standard NATO green, RAL 6014.
Illustration
This illustrates the heater:
Wheels
The two wheels can be stored on top of the heater with the short axles placed into
access holes or the storage compartment . The wheels can be removed or refitted
by a single person, no tools are required. The parking stand can be fixed in a hori-
zontal position when the wheels are removed.
Lifting and carry-
Manual lifting and transporting the unit is carried out by the use of the side handrails,
ing
which are also suitable for the tie-down anchor points. Slots in the skid runners allow it
to be handled by a forklift truck. We have a lifting point in the flue gas outlet, which
makes it possible to lift the heater by a crane.
Skid runners
The base of the cabinet is fitted with skids , so that the heater can slide over ice, snow
or earth with the wheels removed.
Storage compart-
When not in use, the remote thermostat (accessory), CO monitor (accessory), tool kit,
ment
service manual, and wheels are stored within the storage compartment at the rear of
the heater.
Burner compart-
The hinged door at the front of the unit gives complete access to the burner com-
ment, service ac-
partment which houses the oil burner, electrical controls, fuel systems and filter.
cess
At the same time it is the storage room for the power supply cable under transport.
Fig. 1
1
No.
1
Outlet openings
Flue stack
Access holes for wheel stor-
age
Storage compartment
Flue outlet opening
Adjustable fresh air open-
ings
Wheels
Skids
Parking stand
Hinged door
Inlet openings
1
1
Part
Continued overleaf
11