Dantherm 4000 Series 서비스 매뉴얼 - 페이지 3
{카테고리_이름} Dantherm 4000 Series에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dantherm 4000 Series 17 페이지.
페이지 인쇄Warning
Introduction
This installation manual and the product use various displays and labels to ensure safe use.
Failure to follow these instructions could result in injury, death or damage to equipment.
Ignoring these displays and labels and incorrectly using the product could have results as
classified below.
Please read the following warning symbol information before reading the rest of this section,
and be sure to strictly observe all instructions.
General precaution
This product is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the product by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the product.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified person in order to avoid a hazard.
Warning
Failure to follow these instructions could result in death or serious injury
Warning
Caution
Failure to follow these instructions could result in injury or property damage.
Caution
This symbol means something that should NOT be done
Project safety is your responsibility!
Follow the instructions in this manual regarding the installation method and installation
orientation. All work should be performed by qualified personal using safe work practices.
All proper personal protective equipment should be used. PPE required for this installation
includes, but is not limited to:
•
Safety glasses
•
Hard hat
•
Safety shoes
•
Hearing protection
•
Cut resistant gloves
•
Face shield
•
Proper work attire (long sleeve shirt and long pants)
Please strictly observe the following: Special Skill is required to install the Dantherm products.
Non-qualified personnel should not attempt any of the actions shown in this installation
guide. Dantherm shall not be responsible for improper installation or any accidents, damage,
or injury resulting from improper installation.
4
Product description
Overall description
This section describes the overall product and its functionality
Introduction
The Air Conditioner is designed to control the internal temperature of an outdoor enclosure.
The Air Conditioner removes dissipated heat from electronic equipment and is designed to
maintain correct temperature for electronic equipment.
This manual covers a series of air conditioners. Models available are:
Model overview
Cooling
Enclosure
Heater
capacity/
size inch
power /watt
btu
H*W*D
29 -17.3-
4000
1000
11.3
This table shows the accessories available from supplier
Available
accessories
No
Description
707585
Air Filter, A/C 4000
707600
Crankcase heater 115V
707601
Crankcase heater 230V
External over
Minimum supply
Voltage /
current pro-
cord
frequency
tection / A
dimension
115V/60Hz
C20A
AWG 14
230V/50-60hz
C10A
5