Dantherm ACT-7 EU 사용자 설명서 - 페이지 5

{카테고리_이름} Dantherm ACT-7 EU에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dantherm ACT-7 EU 20 페이지.

페이지 인쇄

Installation: Location consideration

Location consideration

Good and correct air ﬂow is, perhaps, the single most important aspect of satisfactory use of

Siting

portable air conditioners. Some examples of how to place the room unit in the most common

(Room unit)

situations are illustrated in the table below. If in doubt seek the advice of your supplier.

Installation

options

one unit

two units

Around the

perimeter

Also be aware of the following:

NOTICE

•

Installation

Description

Ideally the ACT-7 room

unit should be posi-

tioned in the middle of

the shortest wall in the

room blowing down

the length of the room.

If there is more than

one ACT-7 in the same

area, then they would

normally be posi-

tioned side by side,

and equally spaced

along the long wall, all

pointing in the same

direction.

Sometimes it may be

necessary to position

units around the pe-

rimeter of an area but,

in this case, great care

should be taken to

avoid one unit blow-

ing cold air straight

into another which will

adversely affect opera-

tion.

the room unit has to be sited on ﬁrm level ground.

the room unit has to be located away from any possible unauthorised interference.

Condensation on the outside of the room unit may appear, when the room unit operates

at low indoor temperatures as e.g. 10 °C and high relative humidity (80%) at the same

time. If operated under these conditions the units side plate should be wiped off regu-

larly in order to avoid water on the floor.

Illustration