Dantherm ACT-7 EU 사용자 설명서 - 페이지 8

{카테고리_이름} Dantherm ACT-7 EU에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dantherm ACT-7 EU 20 페이지.

Connecting room

unit to heat

exchanger

Top up the tank with the correct anti-

freeze (33%) and water mixture until

the fluid level is between min. and

max. level (check the level through

the inspection window).

Be aware not to mix different types

of antifreeze, in order to protect the

system properly.

(Original speciﬁcation is ethylene

glycol based antifreeze, containing

rust/corrosion inhibitors, suitable for

aluminium systems, 33% giving pro-

tection to -20°C. This speciﬁcation will

protect the entire glycol/water circuit

down to -16°C (-5°F).)

Mount the cap and security plate again.

Step Description

Use the interconnecting line (5-30m)

to connect the ACT-7 room unit to the

heat exchanger.

NB: The interconnecting line should

be routed carefully to avoid any

possibility of kinking or unnecessary

restrictions to the ﬂow of water. The

line will be more likely to kink when

warm.

Connect the condensate drain to the

ACT-7 room unit.

Connect the condensate drain to the

heat exchanger by pushing the clear

hose ends into the grey connector.

Installation: Handling and set-up

Illustration