DanVex DEH-500i 매뉴얼 - 페이지 9

{카테고리_이름} DanVex DEH-500i에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DanVex DEH-500i 14 페이지. Air dehumifiers

• it is forbidden to connect the dehumidifier to the mains, the power and frequency of which

are outside the nominal values of the dehumidifier;

• when using extension cables, they must be fully extended, grounded and of sufficient

conductor cross-section.

4.2 Control Panel

The control panel is designed to set the dehumidification parameters and control the operation

of the unit. The panel contains waterproof control buttons and an LCD display.

The buttons are used for on/off dryer, tasks required humidity level, as well as to control the timer.

The LCD display shows the operating modes, the level of required humidity and the current air

parameters at the installation site dryer.

Control buttons:

ON/OFF - enable/ disable the dehumidifier;

TIMER - enable/ disable the timer to disable or enable;

- increasing the humidity parameter or the timer parameter;

- decreasing the humidity setting or the timer setting.

The dehumidifier is switched on by pressing the ON/OFF button once, the dehumidifier emits a

short beep and the LCD display lights up.

Adjust the desired humidity level, which is supposed to be supported, with the + or - buttons.

The % humidity reading on the display will change during the setup process.

If the current humidity level higher than the set value by at least 2-3%, the dehumidifier will start

working. After turning on the installation, it works in a fully automatic mode. The dehumidifier

will turn off when the set humidity level is reached.

Order automatic start of components when the dehumidifier is switched on:

1. Fan start

2. Compressor start after a short pause

Installation equipped with a safety device that prevents the compressor from restarting

when restarted immediately after shutdown, thus preventing damage to the compressor.

The compressor start delay is 3 minutes.