Danzo DH0196 작동 및 부품 설명서 - 페이지 9

{카테고리_이름} Danzo DH0196에 대한 작동 및 부품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Danzo DH0196 16 페이지. 20g connect and cut hydraulic chain saw

Operating Instructions

Before and periodically during operation you must check the bar oil level and chain tension. We recommend

using a good quality bar oil of the correct viscosity for your areas operating temperatures. Because of the wide

temperature range between winter and summer two different viscosity oils may be required. Tension the chain as

described on page 6. The log being cut must be clamped prior to sawing. Once the log is positioned and clamped

the saw control valve needs to be opened for full flow to cut. After completing the cut reverse the valve and raise

the saw bar. The saw motor only runs when the bar is being lowered. The bar will only receive up to 32 cc of oil

when the saw motor is operating or the bar is feeding down.

For parts and service contact Danzco, Inc. Our hours of operation are 8:00 AM to 4:30 PM, Monday through

Friday, Pacific Time excluding holidays.

Phone 360-264-2141

Fax 360-264-5105

Mail and shipping address:

Danzco, Inc.

1006 143

Ave. S.E.

Tenino, WA 98589