Audiotec Fischer Match PP 86DSP 매뉴얼 - 페이지 13

{카테고리_이름} Audiotec Fischer Match PP 86DSP에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Audiotec Fischer Match PP 86DSP 15 페이지. 8-chanell amplifier with integrated 9-chanell dsp

페이지 인쇄

Installation of a MATCH Extension Card

It is possible to extend the functionality of the

al MATCH Extension Card (MEC) - for example a

Bluetooth

Audio Streaming module, an AUX input

or an USB audio input.

To install a MATCH Extension Card it is necessary

to remove the side panel of the PP 86DSP and re-

place it by the new side panel that comes with the

MEC module.

Attention: Install the MEC module only in the

the MEC module in other devices or slots can

result in damage of the MEC module, the ampli-

devices!

Read in the following the steps how to install a MEC

module:

1. First disconnect all cables from the device.

2. Dismantle the side panel where the System

Connector input is located by removing the Phil-

lips screws.

3. Pull out the bottom plate.

4. Prepare the module for installing it into the de-

vice. Any further mounting information will be

found in the instruction manual of the respective

MEC module.

the device which is marked in the following pic-

ture.

6. Make sure that the MEC module is installed

properly and all pins are fully inserted into the

socket.

panel which is delivered with the MEC module

with the Phillips screws.

8. Bolt the MEC module to the side panel. Pre-

cise mounting information will be found in

the instruction manual of the respective MEC

module.

9. Reconnect all cables to the device.

10.

matically detected by the device and the Status

LED of the MEC module lights up green.

11.

in the DSP PC-Tool software.