DAP Technologies M4000 Series 빠른 시작 매뉴얼

{카테고리_이름} DAP Technologies M4000 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAP Technologies M4000 Series 2 페이지.

페이지 인쇄

Contents

M4010

USB Client Cable

Headset

Installing Memory Cards & the Battery

1. Open the Velcro strap and slide it out

of the unit as shown.

5. Using a T8 Torx driver, remove the four

screws holding the end cap to the unit.

9. Place the end cap on the unit, insert

the screws into their holes, and tighten

those screws using a T8 Torx driver.

Battery

Power Cord

M4020

AC Adapter

Quick Start Guide

2. Twist the battery cover locks (A) to

unlock the battery cover, then lift the

battery cover (B) off.

SD Card

Slot

6. Note the locations of the SD Card slot

and the SIMM Card slot.

10. Reinsert the Velcro through the unit

bracket and secure.

M4000 Series

Overview

LCD Touchscreen

Scan

Keys

Keypad

Power Input

I / O Port

Battery Cover Locks

3. Insert the battery as shown with the label

side facing up.

SIMM Card

Slot

7. Insert the SD Card into the slot with the

mitered corner to the right as shown and

press in until it locks in place.

11. Insert the AC adapter into the power

input.

PN: 778-00002 • February 2011

Quick Start Guide

Scanner LED Indicator

Scan

Keys

Power

Button

Power Input

I / O Port

Speaker

Left Scan Key

4. Replace the cover and twist the locks

closed as shown.

8. Insert the SIMM Card into the slot with

the mitered corner to the left as shown

and press in until it locks in place.

USA

12. Insert the power cord into the wall outlet

and charge the battery for a minimum of

6 hours.

LCD Touchscreen

Power

Button

Keypad

Barcode

Scanner

Headset

Jack