DAPAudio CS-850S 매뉴얼 - 페이지 8

{카테고리_이름} DAPAudio CS-850S에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio CS-850S 12 페이지.

CS-850S

09) Lift the mounting clamps (04) and rotate them clockwise as shown on Fig. 05 and 06.

10) Insert the speaker into the mounting hole. Make sure the flange of the mounting frame (01) is flush on

the ceiling.

11) Use a Phillips 2 screwdriver to turn the quick-turn screws (03) slowly clockwise, as shown on Fig. 07.

The quick-turn screws (03) will release the mounting clamps (04) and they will press the speaker

against the ceiling, securing it into position.

12) Attach the grill (03) to the speaker by pushing it carefully into the bezel (02), as shown on Fig. 08.

Speaker Wiring

To achieve maximum performance from the subwoofer, it is recommended to use good quality CL2 or

CL3 rated speaker cable. For distances bigger than 20 m,14-gauge wire must be used. For shorter

distances, 16-gauge or 18-gauge wire is sufficient.

Make sure the cable meets any local or national regulations.

Depending on the desired output, you can choose which wires of the subwoofer to connect to the

speaker cable.

For 70 V speaker systems:

●

red = 50 W, brown = 30 W, yellow = 15 W, green = 5 W, white = 3 W, black = common

For 100 V speaker systems:

●

brown = 50 W, yellow = 30 W, green = 15 W, white = 5 W, black = common

Note: Make sure the speaker connection polarity is correct. Always connect positive to positive and

negative to negative. In order to provide the best possible sound, all speakers in a system need to be

wired with the same polarity. If the connections to one speaker in a system are reversed, this will result in

loss of the low frequencies and will affect the overall performance of the system.

Order code: D6588

Fig. 05

Fig. 07

Fig. 06

Fig. 08