DAPAudio D3316 제품 설명서 - 페이지 8

{카테고리_이름} DAPAudio D3316에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio D3316 13 페이지.

Controlpanel

1) Signal LED

Indicates the presence of an audio signal.

2) Power LED

Indicates that AC power is connected and the RX-12A is switched on.

3) Protect

Indicates an electrical or thermal fault condition in the power amp.

4) Limit LED

Indicates that the analog soft clipping circuit is active. A soft clipping circuit clips short signal peaks in

a way that is not sounding unpleasant to your ears. Although a soft clipping circuit limits your

dynamic range, it allows you to operate on a higher average volume level.

If the limit led lights up continuously, we strongly suggest lowering the input level using the master

volume (10) control.

5) Speaker out

Speakon fullrange speaker output for connecting a second RX-12A. Make sure the impedance of the

external speaker is minimal 8 Ω.

6) Bass control

Controls the level of the low frequencies.

7) Treble control

Controls the level of the high frequencies.

8) Mic gain

Controls the level of the mic in (13) input.

9) Line gain

Controls the level of the line in (14) input.

10) Master volume

Controls the volume of the RX-12A and the level of the mix out (11) output.

11) Mix out output

Line level electronically balanced Male XLR socket. The mix out signal level depends on the settings

of the master volume (10) control.

Fig. 2