3xLogic VX-2S-CPIR-W 빠른 설치 매뉴얼 - 페이지 2

{카테고리_이름} 3xLogic VX-2S-CPIR-W에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3xLogic VX-2S-CPIR-W 2 페이지. V-series solution

페이지 인쇄

Adjust the position of the camera and tighten

the knob.

Note: The position of the device will need to work for both

the camera and the PIR.

PIR Detection: The PIR sensor can detect motion up to 17-

22' and at 100° range vertically or 130° range horizontally.

Precaution: Do not position in areas of strong light,

unstable lighting conditions or aim at sources of heat.

Remote Viewing & Monitoring

Ensure the connected network provides a DHCP

address and allows outbound access to the internet.

For installations where DHCP is not available or where the

camera is being used with an appliance see Step 5.

Download VSX Setup app from your devices' app store.

b) Follow prompts in the VSX Setup app, and scan the

camera's QR to complete configuration and enrollment.

DEFAULT User and Password is admin/12345.

d) The cameras live view will be displayed in the app for final

positioning.

e) Ensure that the camera is configured with the proper time

zone, auto daylight savings update and set for NTP (auto

time sync).

Setup results can be emailed upon completion for easy

monitoring configuration.

Note: The Multi-Sensor will automatically check for updates and format

the SD card. Please allow 15 minutes before power cycling the camera.

If an email address was set up in the app, the camera will email a status

update when all updates and formatting are complete.

Out of the Box Configuration

Digital Alarm Input

PIR Alarm

Video Motion Detection

Video Recording

Enabled - Normally Closed

Enabled

Record to SD card on event w/ optional SD card

10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3xLOGIC

QUICK INSTALL GUIDE | V-Series Solution | VX-2S-CPIR-W

*Camera diagrams are not to scale. Diagrams provided as viewing angle reference only.

Non-DHCP Applications

A laptop connected to the same network as the

camera will be required to discover the camera and

assign a valid IP address.

Download and install the All-in-One PC Setup Utility for

Windows from:

http://www.3xlogic.com/support-center/software

b) The utility will automatically detect cameras on the

network (click Refresh to refresh the list).

Select the desired device from the list of available cameras.

d) Click IP Setup and assign the desired IP.

e) Re-select the desired device and click Next to begin setup

Fill out installer and company information.

g) Login with the default credentials, then reset the default

username and password.

h) Confirm the camera Live View preview is as desired and

click Continue.

Adjust any/all camera settings including the camera name

and Connect alias.

Fill out remaining information and complete steps in the

setup tool to receive an installation summary e-mail.

Note: The Multi-Sensor will automatically check for updates and format

the SD card. Please allow 15 minutes before power cycling the camera. If

an email address was set up in the app, the camera will email a status

update when all updates and formatting are complete.

All other trademarks are the property of their respective owners. Revised: December 6, 2016