DAPAudio HS-30R 매뉴얼 - 페이지 6
{카테고리_이름} DAPAudio HS-30R에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio HS-30R 8 페이지.
페이지 인쇄
HS-30R
Description of the device
Features
Power taps:
100V: 3,75/7,5/15/30W
•
70V: 1,9/3,75/7,5/15/30W
Line voltage: 70/100V
•
Impedance: 8 Ω
•
Frequency response: 380-6,5 kHz
•
Sensitivity: 107 dB
•
Housing: Aluminum
•
Color: Gray
•
IP rating: IP66
•
Dimensions: 290 x 245 x 250 mm (LxWxH)
•
Weight: 2,1 kg
•
Installation
01) Use a screwdriver to turn the power tap switch and choose the desired wattage:
1,9/3,75/7,5/15/30W (70V) or 3,75/7,5/15/30W (100V).
02) Connect the common cable to the black cable.
03) Connect the main feed cable to the white cable.
Troubleshooting
No Sound
Always check if all the cables and cords are connected. Always turn off power to the area before
checking the wires, to prevent electric shock.
If everything works properly and there is still no sound, revisit the manufacturer's instructions to make sure
they were followed during installation. If everything was installed correctly and there is still no sound, you
may want to consider bringing in a professional to take a look at your speaker.
Sound Warping
If the sound coming out of your speaker is loud enough, but seems to be warped or distorted, your treble
or bass levels may need to be adjusted.
If there are not many pieces of furniture in the room and the floor has no carpet or rug, then you will most
likely have to set your treble to minus. With very little in the room to absorb the sound, too much treble
can make the sound bounce off of fixtures in the room, making it tinny sounding.
With the bass, if the speaker is too close to a wall and is not aimed properly, then you will need to set the
bass to minus, to stop the low tones from bouncing off of the walls or large pieces of furniture.
Ordercode: D6542
5
Fig. 01