DAPAudio CA-3150 매뉴얼 - 페이지 9
{카테고리_이름} DAPAudio CA-3150에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio CA-3150 12 페이지.
페이지 인쇄
CA-3150
Troubleshooting
CA-3150
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. If the unit operates properly, do not carry out following steps.
01) If the device does not operate properly, unplug the device.
02) Check power from the wall, all cables, connections, etc.
03) Replace the fuse. See page 7 for more information.
04) If all appears to be O.K., plug the unit in again.
05) If nothing happens after 30 seconds, unplug the device.
06) Return the device to your DAP Audio dealer.
Product Specifications
Output Power
Stereo 2Ohm: 2 x 230W RMS
Stereo 4Ohm: 2 x 150W RMS
Stereo 8Ohm: 2 x 90W RMS
SUB 2Ohm: 1 x 360W RMS
SUB 4Ohm: 2 x 220W RMS
SUB 8Ohm: 2 x 120W RMS
Frequency response: 20Hz – 20kHz, +0/-1dB
THD: <0.1%
S/N rate: >96dB A-weighted
Crosstalk: >70dB
Damping factor: >180
Gain: 28V
Input sensitivity: 0,9-1,1V (+/-1dBv)
Input impedance: 20kOhm balanced, 10kOhm unbalanced
Output mode: Stereo, Bridge
Amp technology: Class D
Power supply: SMPS
Protection: Clip Limiter (Fixed)
Cooling: Forced-air by radial fan
Air flow: Front to back
Installation depth: 278 mm (excluding connectors)
Input connectors: Euroblock IN
Output connectors: Euroblock OUT
Power connector: IEC
Input voltage: 210-240V AC, 50/60Hz
Power consumption: 500W
Fuse: T4AL/250V
Dimensions:
483 x 281 x 44 mm (LxWxH)
19" x 1HE
Weight: 4,3 kg
Design and product specifications are subject to change without prior notice.
Ordercode: D4511
Short Circuit
Overheat
Overload
DC Voltage
Soft Start
Website:
www.Dap-audio.info
Email:
8