DAPAudio CX-1500 사용자 설명서 - 페이지 6

{카테고리_이름} DAPAudio CX-1500에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio CX-1500 12 페이지. Cx series

CX Series

Functions & Features



2x Channel in and Link out.



2x Speakon out.



Built-in Clip Limiter.



Switchable entrance sensitivity: 0.775V and 1.4V.



Bridge, parallel or stereo mode.



Efficient heat-sink.



Variable speed cooling fan.



Front panel level gain control.



Excellent audio signal performance.



Very little harmonic distortion (THD), intermodulation distortion (SMPTE-IM), transient intermodulation

distortion.

Remove all packing materials from the Vision. Check that all foam and plastic padding is removed.

Screw the equipment into a 19" rack. Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.

Install this device on a flat surface, not bending or curved.

Do not supply power before all components of the system are set up and connected properly.

The three-position, recessed Mode Select switch (located on the rear panel) configures the amplifier for

either Stereo. Parallel or Bridged Mono Mode. Amplifiers are factory-configured for Stereo Mode.

CX-500/900/1500/2100/3000