DAPAudio D4190 매뉴얼 - 페이지 10

{카테고리_이름} DAPAudio D4190에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio D4190 18 페이지.
DAPAudio D4190에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지)

Mode Selection

The three-position, recessed Mode Select switch (located on the rear panel) configures the amplifier for

either Stereo. Parallel or Bridged Mono Mode. Amplifiers are factory-configured for Stereo Mode.

Stereo Mode

In Stereo Mode, both channels operate independently, with their input attenuators controlling their

respective levels. Signal at Channel A's input produces output at Channel A's output while signal at Channel

B's input produces output at Channel B's output.

Important !!!

Absolute minimum nominal load Impedance for stereo operation Is:

TAS1100 and TAS4000:

TAS1500, TAS1900 and TAS2400:

Parallel Mode

When set to Parallel Mode, a signal applied to Channel A's input will be amplified and appear at outputs

of both Channels A&B.

Important !!!

Absolute minimum nominal load Impedance for parallel operation Is:

TAS1100 and TAS4000:

TAS1500, TAS1900 and TAS2400:

4 Ohm per channel.

2 Ohm per channel.

4 Ohm per channel.

2 Ohm per channel.

Fig. 4

Fig. 5