Duratax NITRO DEMON 조립 및 작동 매뉴얼 - 페이지 7

{카테고리_이름} Duratax NITRO DEMON에 대한 조립 및 작동 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratax NITRO DEMON 20 페이지.

❏

4. Use a hobby knife or diagonal cutters to remove

the servo mounting blocks from the radio tray. Make

sure all of the flashing is removed from inside the

servo compartment to assure a proper servo fit. Save

the servo mounting blocks.

❏

5. Place the standard throttle servo into the radio

tray. Note: Notice the direction of the servo spline

when installing. Run the servo lead into the radio box

through the hole in the side.

❏

6. Mount the servo to the radio tray using four

mounting screws included with the radio system. Use

one of the servo mounting blocks that you cut out of

the radio tray in step 4 and place it against the under

side of the radio tray under the slotted holes. The

screws should go through the servo, the radio tray and

thread into the servo mounting block. Note: Make

sure to use the servo mounting block on the end

with the slotted mounting holes.

❏

7. Place the high torque steering servo into the

radio tray. Note the direction of the servo spline

when installing. Run the servo lead through the hole

in the side of the radio box.

❏

8. Mount the servo to the radio tray using four

mounting screws included with the radio system. Use

the other mounting block that you cut out of the radio tray

in step 4 and place it against the under side of the radio

tray under the slotted holes. The screws should go

through the servo, the radio tray and into the servo

mounting block. Note: Make sure to use the mounting

block on the end with the slotted mounting holes.

❏

9. Cut two of the arms off the throttle servo horn by

scoring both sides of the arm with a hobby knife and

snapping off the arms with pliers.