DAPAudio D6145 매뉴얼 - 페이지 9

{카테고리_이름} DAPAudio D6145에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio D6145 15 페이지.

21. 8 Ω terminal

Connect this terminal to the + terminal of your 8 Ω speaker(s). In case of using several speakers.

Make sure that the total speaker load is 8 Ω. The total power rating of the low impedance speakers

connected to this terminal summed, should be at least 30W.

22. 100V terminal

Connect this terminal to the + terminal of your 100V speaker(s). In case of using several speakers make

sure all speakers are wired in parallel.

The total power rating of the 100V-speakers connected to this terminal summed, should never exceed

30W.

23.

AC Inlet with integrated fuse holder

This connector is meant for the connection of the supplied main cord. Connect one end of the power

cord to the connector, the other end to the mains, then turn on the power (14) switch to operate the

unit.

Make sure that the supply voltage matches the operation voltage before connecting the unit to mains.

Replace the fuse only with a fuse of the same specification (230V:T800mA, 115V:T1,6A).

24.

GND Screw

This screw offers a separate ground connection. Can be useful in case of grounding problems.

25. 4 Ω terminal

Connect this terminal to the + terminal of your 4 Ω speaker(s). In case of using several speakers.

Make sure that the total speaker load is 4 Ω. The total power rating of the low impedance speakers

connected to this terminal summed, should be at least 30W.

26. 70V terminal

Connect this terminal to the + terminal of your 70V speaker(s). In case of using several speakers make

sure all speakers are wired in parallel.

The total power rating of the 70V-speakers connected to this terminal summed, should never exceed

30W.

27. Line out

RCA stereo line lvel output for connecting a recording device or an additional amplifier.

28. Line 3 input

RCA stereo input for connecting a line level device such as an I-pod, CD player etc.

29. Line 2 input

RCA stereo input for connecting a line level device such as an I-pod, CD player etc.

30. Mic 3 input

Mic level XLR input for channel 3. Accepts balanced and unbalanced inputs.

31. Mic 2 input

Mic level XLR input for channel 2. Accepts balanced and unbalanced inputs.