DAPAudio D6507 매뉴얼 - 페이지 7

{카테고리_이름} DAPAudio D6507에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio D6507 12 페이지.

Rear panel

11) AC Inlet with integrated fuse holder.

This connector is meant for the connection of the supplied main cord. Connect one end of the

power cord to the connector, the other end to the mains, then turn on the power switch to operate

the unit.

Note: Please make sure that the supply voltage matches the operation voltage before connecting

the unit to mains.

12) GND Screw.

This screw offers a separate ground connection. Can be useful in case of grounding problems.

13) DC 24V Input.

Used to connect an external back up power supply of 24Vdc (e.g.

14) Outputs.

Use this RCA connectors to connect up to three power amplifiers to your IPS-MPA.

15) Aux 1-3 input

16) EMC 1-2 input

These inputs have priority (just like MIC 1). If the IPS-MPA detects a signal at one of the EMC inputs, it

mutes the normal (non priority) inputs. The EMC inputs starts muting the normal (non priority)

channels at an input level of -10dB and completely shuts off the other channels if the level at the

EMC input reaches 0dB.

17) MIC 2- 5 input

Replace the fuse only with a fuse of same specification (T315mA).

Battery).

Fig. 2