DAPAudio DSA-250 사용자 설명서 - 페이지 9

{카테고리_이름} DAPAudio DSA-250에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio DSA-250 18 페이지. Dsa-series
DAPAudio DSA-250에 대해서도 마찬가지입니다: 사용 설명서 (19 페이지)

Backpanel

10.

AC Inlet.

This connector is meant for the connection of the supplied main cord. Connect one end of the

power cord to the connector, the other end to the mains, then turn on the power switch (9) to

operate the unit.

Note: Please make sure that the supply voltage matches the operation voltage before connecting

the unit to mains.

11. Output B Speakon Connector.

Using speakon-type speaker cables, make connections to both the channel A and channel B

connectors for Stereo or Parallel mode, to channel A connector for Bridged mono mode.

12. Output A Speakon Connector.

Using speakon-type speaker cables, make connections to both the channel A and channel B

connectors for Stereo or Parallel mode, to channel A connector for Bridged mono mode.

13. Channel B In/Through Connectors

Using speakon-type speaker cables, make connections to both the channel A and channel B

connectors for Stereo or Parallel mode, to channel A connector for Bridged mono mode.

14. Stereo/ Bridge Switch.

The two-position, Mode Select switch (located on the rear panel) configures the amplifier for

either Stereo or Bridged Mono Mode.

15. GND Switch.

To eliminate ground loops, put the switch in "OFF" position.

16. Channel A In/Through Connectors

Using speakon-type speaker cables, make connections to both the channel A and channel B

connectors for Stereo or Parallel mode, to channel A connector for Bridged mono mode.

17. Air cooling windows

This part is the air cooling window. Don't obstruct it.

Fig. 3