DAPAudio IPS-AM 매뉴얼 - 페이지 6

{카테고리_이름} DAPAudio IPS-AM에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio IPS-AM 14 페이지.

Description of the device

Intelligent fire alarm interface

Auto activating function

Minicomputer intelligent interface

Up to neighbor +/-4 zones can be activated by inputting alarm signal

Controllable 30 channels each set. Up to 120 channels can be controlled by using multiple units.

1. AC Power Switch.

This is the main Power switch. Press to turn the amplifier on.

Link Status Display.

When operating the unit stand alone, the HOST LED lights up. If the unit is linked with other IPS-AM's the

LED's will indicate following:

HOST, controls CH1-CH30.

SLAVE1, controls CH31-CH60.

SLAVE2, controls CH61-CH90.

SLAVE3, controls CH91-CH120.

E.g. SLAVE 3 LED and CH12 LED light both up. This indicates that alarm CH102 is active.

Alarm Status Display.

Turn on the power switch, alarm LEDs 1-30 light up green, which means the unit is in

standby status. When receiving an alarm signal on the alarm in, the corresponding channel's LED will

light up red.

All Alarm LED.

The LED will light up when a general alarm is active. A general alarm can only be activated or

deactivated by the all alarm switch.

All Alarm Button.

If the ALL ALARM BUTTON is pressed, all channels will go into alarm. Pressing the ALL ALARM Button

again will erase the general alarm.

6. AC LED

Indicates that AC power is connected and the device is turned on. The LED will dim if the mains

power fails.

7. DC LED.

Indicates that an external 24Vdc power supply is present.

Front panel