DAPAudio MA-460 매뉴얼 - 페이지 8

{카테고리_이름} DAPAudio MA-460에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio MA-460 16 페이지.

7. Zone VU meter

Indicates the signal level at the output of the corresponding zone. If the red LED blinks frequently or lights

continuously, the output is likely to enter clipping. If this happens, we strongly suggest lowering the

corresponding zone level (8) control.

8. Zone level control

Use to adjust the output volume for zone 1-4.

9.Monitor button

Allows you to monitor one or more zones with your headphone (14) output or monitor (23, 24) outputs.

10. Power LED

Indicates the amplifier is turned on.

11. Channel level control

Use to adjust the level for channel 1-5.

12. Channel mute button

Pushing this button allows you to mute the corresponding channel. If a channel is muted, the

corresponding mute (4) LED will light up.

13. Monitor VU meter

Indicates the signal level at the output of the corresponding zone. If the red LED blinks frequently or lights

continuously, the output is likely to enter clipping. If this happens, we strongly suggest lowering the

monitor level (15) control.

14. Monitor output

You can connect a pair of headphones with a minimum impedance of 32 Ohm to this stereo 1/4" jack.

The jack should be wired as Tip=left, Ring=right and sleeve=ground.

15. Monitor level control

Is used to adjust the volume level of your headphone (14)/ monitor (23, 24) outputs.

16. AC power switch

This is the main Power switch. Push to turn the amplifier on.