DAPAudio TAS-1100 매뉴얼 - 페이지 9

{카테고리_이름} DAPAudio TAS-1100에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio TAS-1100 18 페이지.
DAPAudio TAS-1100에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지)

Operation

Installation

Remove all packing materials from the DSA. Check that all foam and plastic padding is removed.

Secure the equipment into a 19" rack. Connect all cables.

Connecting Power / Circuit Size Requirements.

The actual current draw, the amplifier demands from the AC mains, depends on many factors (its load,

output level or the crest factor of its program material).

The power requirement is rated under typical music conditions, with both channels driven so those peaks

are just at the clipping point.

Make sure the mains voltage is correct and is the same as printed on the rear of the amplifier. Damage

caused by connecting the amplifier to improper AC voltage is not covered by any warranty. Unless

otherwise specified when ordered. DAP audio amplifiers shipped to customers are configured as follows:

North America 120VAC/60Hz

Europe 230VAC/50Hz

Asia 220VAC /50Hz/60Hz

Australia 240VAC/50Hz

South America 120VAC/60Hz or 220VAC/50Hz

Japan 1OOVAC/50Hz

NOTE: Always turn off and disconnect the amplifier from mains voltage before making audio

connections. Also, as an extra precaution, have the attenuators turned down during

power-up.

Connecting Inputs.

Use the XLR input connectors on the rear to supply audio signals to your DAP Audio TAS Series amplifier. The

connectors accept balanced and unbalanced audio connections. (The TAS Series amplifiers are configured

standard with "Pin 2 hot" on XLR inputs. The Link connector can be used to loop the audio Input to another

amplifier Input. For more Information, see the section on Connection cables page 10.

Connecting Outputs.

Speakers are connected using Speakon connectors. For examples see figures 4, 5 and 6.