DAPAudio TAS-1100 매뉴얼 - 페이지 11

{카테고리_이름} DAPAudio TAS-1100에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio TAS-1100 18 페이지.
DAPAudio TAS-1100에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지)

Bridged Mono Mode

Bridged Mono Mode straps both amplifier channels together to make a very powerful, single-channel

monaural amplifier. One channel "pushes" and the other "pulls" equally, doubling the power over that of

channel alone. Signal is applied to the Channel A input only. Both attenuators are used to control signal

level; in addition, both must be adjusted to the same setting. Only channel A input may be

Use extreme caution when operating the amplifier In Bridged Mono Mode. Never ground either side of

the speaker cable when the amplifier Is in Bridged Mono Mode; both sides are "hot. "If an output patch

panel is used, all connections must be Isolated from each other and from the

Important!!!

Absolute minimum nominal load Impedance for bridge operation Is:

TAS1100 and TAS4000:

TAS1500, TAS1900 and TAS2400:

Connecting amplifier outputs to oscilloscopes or other test equipment while the

amplifier is in bridged mode may damage both the amplifier and test equipment!

8 Ohm.

4 Ohm.

used.

panel.

Fig. 6