DAPAudio VPA-250 제품 설명서 - 페이지 7

{카테고리_이름} DAPAudio VPA-250에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio VPA-250 13 페이지. Palladium vpa series
DAPAudio VPA-250에 대해서도 마찬가지입니다: 사용자 설명서 (13 페이지)

페이지 인쇄

Installation

Palladium 100V Installation

Remove all packing materials. Check that all foam and plastic padding has been removed.

Screw the equipment into a 19" rack. Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.

Do not supply power before

DC power or battery supply's connection

•

The unit will also operate with 2 external 24V batteries or another source with positive and negative (-)

voltage against ground. Power connection is made at the DC terminal strip on the real panel.

•

If the AC power supply fails, transfer to DC power is instantaneous, automatic and silent.

•

The amplifier is not capable of recharging the connected battery.Thus, it is recommended to have a

suitable device at hand. When the amplifier is on the DC power source, the nominal power handling

capacity operated drops and will not reach full power capacity.

all components of the system are

set up and connected properly.

Fig. 3