DAPAudio IMIX-7.1 매뉴얼 - 페이지 9

{카테고리_이름} DAPAudio IMIX-7.1에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio IMIX-7.1 16 페이지. 7 channel 2u install mixer

IMIX 7.1

12. Phono-line 1 LED

Indicates that the phono-line 1 input is selected.

13. Phono-line 1 LED

Indicates that the line 2 input is selected.

14. Input Selection button (Line 1/Line 2)

With this button you can select between two sets of inputs per channel.

15. Peak LED

The peak LED shows signal peaks in a channel's incoming signal. If the red peak LED frequently blinks or

constantly lights, the corresponding channel is likely to enter clipping and you have to reduce the input's

amplification using the corresponding gain (33-37) control on the back. The peak LED lights at a level of 8

dB below clipping. Make sure that the peak LED lights only briefly during dynamic peaks.

16. PFL button

The PFL button (pre fade listening) is designed to route the channel input to the monitor section

independent of the individual channel's volume fader setting. It is possible to assign more than one

channel simultaneous to the PFL bus.

17. Channel fader

A logarithmic 50mm fader, which controls the volume of the corresponding channel. The overall volume

is set with the master control.

Ordercode: D2350