DAPAudio EM-193B 매뉴얼 - 페이지 8

{카테고리_이름} DAPAudio EM-193B에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio EM-193B 13 페이지.
DAPAudio EM-193B에 대해서도 마찬가지입니다: 매뉴얼 (13 페이지)

Changing the frequency of the transmitter

1) Press and hold the set(1) button for 3 seconds. The display shows FREQUE. After a second, the display

shows the actual frequency while the MHz symbol blinks.

2) Use the up(3) and down(2) buttons to select the desired frequency.

3) Press the set(1) button again to store the setting. The display will briefly show STORE. Now the setting is

stored in memory.

1) Press and hold the set(1) button for 3 seconds. The display shows FREQUE. After a second, the display

shows the actual frequency while the MHz symbol blinks.

2) Tap the set(1) button until the display shows SENSIT.

2) Use the up(3) and down(2) buttons to select the sensitivity.

3) Press the set(1) button again to store the setting. The display will briefly show STORE. Now the setting is

stored in memory.

The EM-193B has a locking function. When activated, the locking function blocks all keys so you can't

accidentally switch the EB-16 off or change the frequency while performing.

1) Press and hold the set(1) button for 3 seconds. The display shows FREQUE.

2) Tap the set(1) button until the display shows LOC OFF.

3) Press the up(3) buttonto turn the lock function on.

4) Press the set(1) button again. The display will briefly show STORE. Now the setting is stored in memory.

1) Press and hold the set(1) button for 3 seconds. The display shows FREQUE.

2) Tap the set(1) button again until the display shows LOC ON.

3) Press the down(2) button to turn the lock function on.

4) Press the set(1) button again. The display will briefly show STORE. Now the setting is stored in memory.

 Make sure you can always see a receiver antenna from the transmitter position.

 Keep the distance from transmitter to receiver antenna as short as possible.

 Point the receiver antennas away from each other at 45 degrees angle from vertical position.

 Avoid placing the receiver antennas near metal surfaces and obstructions.

 Replace battery as soon as low battery LED lights.

 If stacking or rack mounting receivers in a multiple system setup. Do not allow antennas to cross.



Perform a walk-through before performance or presentation. If dead spots are found, adjust the

location of the receiver. If dead spots remain, mark the dead spots and avoid them.