DAPAudio HM-30 매뉴얼 - 페이지 5

{카테고리_이름} DAPAudio HM-30에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio HM-30 8 페이지.
DAPAudio HM-30에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지)

HM-30

Description of the device

Features

The DAP HM-30 is a modern rendition of the legendary crystal-type microphone, used with a blues harp.

Type: Dynamic, moving coil

•

Frequency response: 40 Hz - 16 kHz (-3 dB)

•

Polar pattern: Cardioid

•

Sensitivity: 1,2 mV/Pa -58 dB –

•

Max. SPL: 140 dB

•

Impedance: 220 Ohm

•

Included: Stand mount and 3-pin XLR cable

•

Connections: 3-pin XLR IN

•

Dimensions: 77 x 68 x 90 mm (LxWxH)

•

Weight: 0,28 kg

•

Remove all packing materials from the HM-30. Check if all foam and plastic padding is removed.

Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set all volume and gain controls on your mixer, mic preamp or recording device to their minimum settings

before connecting the microphone. Make sure that the phantom power is turned off!

Once the HM-30 is plugged in, move the channel fader gradually to the 0dB position. Adjust the input

gain using your channel peak LED or a VU-meter.

01) Plug one end of the included 3-pin XLR cable into the XLR input on the HM-30.

02) Plug the other end of the XLR cable into your mixing board.

Ordercode: D1380

Fig. 01