Duratool 5051259025103 지침 - 페이지 3
{카테고리_이름} Duratool 5051259025103에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratool 5051259025103 4 페이지.
페이지 인쇄
OVERVIEW
Iron Holder
Power LED
Soldering Iron
•
Between use (or during breaks), always put the soldering iron in the holder.
•
Lower the temperature during breaks as this extends the life of the tip.
•
When the soldering work is done, adjust the temperature to 270
power first, clean the tip and tin with fresh solder to protect it from oxidation.
•
Never file down the tips or attempt to clean using abrasives.
•
Replacement tips are available for this iron. See our web
pages or catalogue.
TIP REPLACEMENT
•
Replacing the tip should only be done when the iron is switched off and at room
temperature.
•
The tip can be changed or replaced by unscrewing the knurled nut barrel.
•
It is imperative that the iron is switched off, unplugged and allowed to cool before
and after tip replacement.
Caution: Damage could occur if the iron is left on without the tip inserted.
•
After removing the tip, blow out any remaining oxide dust that may have formed in
the tip retaining area of the barrel.
Warning: Care should be taken to avoid getting dust in your eyes.
•
Replace the tip and tighten the knurled nut barrel assembly with your fingers.
•
Pliers should only be used to tighten the nut if loosening occurs when the iron is
hot.
•
Do not over tighten the nut as the element could be damaged.
Temperature Control
Sponge
3
Soldering Station
o
C or switch off the