Duratool D01842 지침 - 페이지 4
{카테고리_이름} Duratool D01842에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratool D01842 4 페이지. 48w temperature controlled soldering station
페이지 인쇄CLEANING
•
Cleaning should only be done when the iron is switched off and at room
temperature.
•
The iron may be cleaned with a damp cloth and a small amount of liquid detergent
if necessary.
•
Never submerse the soldering iron in liquid or allow any liquid to enter the case.
•
Do not use any chemicals, abrasives or solvents that could damage the soldering
iron.
TROUBLESHOOTING
•
Tip heats intermittently -
•
Tip will not reach set temperature - Defective heating element
•
Solder will not wet the tip -
SPECIFICATIONS
Power Consumption
Input Voltage
Temperature Range
Weight
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste
Electrical & Electronics Equipment (WEEE). Any WEEE marked products must
not be mixed with general household waste, but kept separate for the treatment,
recovery and recycling of the materials used. Contact your local authority for details
of recycling schemes in your area.
Mains cord damaged or a loose connection.
Tip temperature is too high.
Tip is badly oxidized and requires cleaning.
48W
220-240V~50Hz
150-450°C
2.1kg
4
Made in China. PR2 9PP
Man Rev 1.0