Belimo FS Series 지침서 - 페이지 5

{카테고리_이름} Belimo FS Series에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Belimo FS Series 18 페이지. Replacement of multiproducts motors
Belimo FS Series에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 교체 (19 페이지)

Belimo FS Series 지침서

Cross Reference

One is not replacing the Multiproducts motor itself, but rather installing a new actuator
on the damper shaft. In most cases the new installation is the same as the modern
UL555S listed method. There were many models of Multiproducts used and no
complete cross reference exists. Some are listed below. Most were 120V, but verifying
voltage is necessary.
* More important than the torque rating is the
damper manufacturers' UL555S testing.
Each manufacturer tests Belimo separately
and has different sizes UL555S listed.
Among the models that the FSLF120 replaces are the 2781 (Ruskin), 2985E (120V
Greenheck), 3159 (Air Balance), 5953, 5949, M12, 6347, and 5186. The 2986A (24V) is
replaced by the FSLF24.
A general rule of thumb is that the FSLF replaces motors on dampers 3 sq.ft. and
smaller and the FSNF replaces motors on dampers greater than 3 sq.ft. The Belimo
FSLF has passed UL555S testing at larger sizes; however, with age and corrosion, it is
best to be conservative. Call if questions exist.
The Multiproducts motors varied in torque, CW or CCW rotation, length of shaft, shaft
shape, electrical mounting, and voltage. All of these except voltage may be ignored with
focus on the damper itself.
It is technically superior to remove the old motor and replace using the methods
shown below. This also produces an installation that is closest to the present UL
mounting methods.
THERE ARE A LARGE NUMBER OF DIFFERENT MULTIPRODUCTS
MOTORS AND APPROACHES TO SPRING RETURN. CALL BELIMO
FOR ANY NOT COVERED HERE.
INSTRUCTION SHEET
NOTE. Although an actuator may pass a
larger sized damper use the UL listed sizing.
See
www.belimo.us/firesmoke
reference by manufacturer.
Replacement of Multiproducts motors with Belimo FSxx Series
for a cross
5