Duratool D03124 빠른 시작 매뉴얼 - 페이지 4
{카테고리_이름} Duratool D03124에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Duratool D03124 9 페이지. Digital multimeter autoranging
Duratool D03124에 대해서도 마찬가지입니다: 매뉴얼 (10 페이지)
페이지 인쇄
BUTTONS
Button
FUNC
Function select key that acts with trigger. Use the key as switch of DC/
AC current, Diode/Continuity and Hz.
HOLD
Press "HOLD" to enter and exit the hold mode in any mode.
MAX
Press this key once, the maximum value is holding (Will displays 'MAX'
symbol in the LCD). After pressing the key, ND will keep working, and the
display value are always up dated and kept the maximum value. NOTE:
The actual gained value is not the peak value.
When press and hold the key for over 2 sec, will enable the back light.
Press the key again, the back light will disable.
DISPLAY
1
2
3
4
1 Auto-power off
2 DC voltage indicator
3 Negative reading indication
4 AC indicator
5 Diode Measurement
6 Continuity buzzer mode
7 Max value indicator
MEASURE AC & DC VOLTAGE
•
Insert the red test lead into the "V
COM terminal.
•
Set the rotary switch to DC or AC range.
Connect the test lead across with the object under test.
•
The measured value will be show on the LCD display.
•
When DC or AC voltage measurement has been completed, disconnect the
connection between the test leads and the circuit under testing.
5
6
7
Ω
" input terminal and the black test lead into the
4
Details
8
14
8
Hold mode
9
Low battery indicator
10 Frequency indication
11 Temperature Unit
12 Function indicator
13 Resistance indicator
14 Main measurement display
9
10
11
12
13