Abus PLSG10000 사용자 설명서 - 페이지 9

{카테고리_이름} Abus PLSG10000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Abus PLSG10000 16 페이지. Z-wave indoor siren
Abus PLSG10000에 대해서도 마찬가지입니다: 빠른 매뉴얼 (4 페이지)

페이지 인쇄

2.2. Planning, assembly and installation

The unit uses low-power radio signals to communicate with the Z-Wave Gateway. To achieve the best

results, please note the following:



Please do not attach directly to metal levels or metal structures as this may limit the range.



The device has a radio range of up to 40 m.



The battery life of the device is reduced if the radio connection to the Z-Wave Gateway is not direct

but via a repeater.



The siren should be mounted in a vertical position about 2 meters from the ground.

Mounting instructions:

Use the bracket as a template to mark the position of

two drill holes on the wall.

Fix the bracket to the wall using the supplied plugs

and screws.

Do not tighten the screws too tightly to avoid

damaging the bracket.

1 Carefully place the base on the bracket from above

and then press the unit against the wall.

2. make sure that the red marked pins snap into

place properly.

To release the base from the holder, press the

latched pins.

English