DAPAudio DS-CM-4 매뉴얼 - 페이지 10
{카테고리_이름} DAPAudio DS-CM-4에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio DS-CM-4 15 페이지.
페이지 인쇄19. Record RCA Unbalanced Out
Use these to connect a recording device.
20. Channel 4 L1 RCA Input
Use to connect a line level device.
21. Channel 3 CD/PHONO Selector
Used to set the input level for the PH/L1 Input (29) to either phono or line level.
22. Channel 2 CD/PHONO Selector
Used to set the input level for the PH/L1 Input (31) to either phono or line level.
23. Channel 1 L1 RCA Input
Use to connect a line level device.
24. GND
Use to connect the ground wire of your turntable.
25.
AC Inlet with integrated fuse holder.
This connector is meant for the connection of the supplied main cord. Connect one end of the power
cord to the connector, the other end to the mains, then turn on the power switch to operate the unit.
Note: Please make sure that the supply voltage matches the operation voltage before connecting
the unit to mains.
26. Master RCA Unbalanced Out
Use these outputs to connect an amplifier with unbalanced inputs.
27. Channel 4 L2 RCA Input
Use to connect a line level device.
28. Channel 3 L2 RCA Input
Use to connect a line level device.
29. Channel 3 PH/L1 RCA Input
Use to connect either a Line level or Phono level device. Depending on the position of the Channel 3
CD/Phono Selector (21)
30. Channel 2 L2 RCA Input
Use to connect a line level device.
31. Channel 2 PH/L1 RCA Input
Use to connect either a Line level or Phono level device. Depending on the position of the Channel 2
CD/Phono Selector (22)
32. Channel 1 L2 RCA Input
Use to connect a line level device.
33. MIC 2 Jack Unbalanced Input
MIC 2 channel ¼" unbalanced microphone input.
Replace the fuse only with a fuse of same specification (T250mA).
8