DAPAudio DS-CM-6 제품 설명서 - 페이지 14

{카테고리_이름} DAPAudio DS-CM-6에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAPAudio DS-CM-6 16 페이지.

Replacing the crossfader

1. Unscrew the fader(B) screws. Do not touch the innerscrews(C). Carefully remove the old crossfader

and unplug the cable.(D)

2. Plug in the new Crossfader, attach the cable (D)and place the new Crossfader back in the mixer.

3. Screw the Crossfader into the mixer using the fader plate screws.

4. Replace the fader knob.

DAP Audio-CD-Player DS-CM-6

This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps

below in sequence until a solution is found. Once the unit operates properly, do not carry out following

steps.

1. If the device does not operate properly, unplug the device.

2. Check power from the wall, all cables, connections, etc.

3. If all of the above appears to be O.K., plug the unit in again.

4. If nothing happens after 30 seconds, unplug the device.

5. Return the device to your DAP Audio dealer.

Fig. 3